Plunge Roundover Bit Edge Forming This chamfer bit is designed

This chamfer bit is designed to cut a 45 degree angle on your work piece

DOVETAIL: Dovetail finger pattern adds a stylish

two flute flush trim bit with 3/8" cutting diameter

offering a seamless fit for clean and hidden hinge installation

ROUNDING OVER UNDERMOUNT: Ideal for trimming and rounding the edges of countertops and sink bowls after installation

Plunge Roundover Bit Edge Forming This chamfer bit is designedMaterials: Natural woods, composite woods, hard plastics Recommended RPM: 14,000 16,000 (max 18,000) Plunge Roundovers can cut a flat bottom while providing that traditional roundover edge. These bits can also be used to cut out your project, leaving only the traditional roundover edge on the side of your workpiece. TOOL SPECS: Carbide tipped traditional roundover & edge trim bit with 1 4" radius, 3 4" large diameter, 1 4" small diameter, 1 2" shank,