Aprilia Suspension Swingarm Dog-bone Bearing Removal and Installation Tool pre-order Bearing removal tool

Bearing removal tool

The bracket is 5mm thick

A damper arm extractor tool is available separately for easy removal of arm for servicing

This mounting bracket facilitates the mounting of a Garmin GPS (or any other bracket with AMPS mounting hole pattern) centrally over the bar clamps on any KTM with 90 x 38 mm bar clamp bolt spacing pattern

There are two very similar Ferrex machines - the 37K is identifiable by the model label attached to the machine and the grey front grille

Aprilia Suspension Swingarm Dog-bone Bearing Removal and Installation Tool pre-order Bearing removal toolPlease note the lead time for this item is approximately one week as the tool is made to order. An extra tough version of this tool is available at additional cost for bearing that are fully rusted in! That version comes with a steel drive tool and a hardened steel drive bolt. Contact me for details. Service tool for removal and installation of rear aprilia rear suspension linkage "dog bone" bearings. The tool can also be used to remove the suspension