Raymarine 20M Backbone Cable f/SeaTalkng [A06037] Lighting | Interior / Courtesy Light 362 Triple rod holder permanent

362 Triple rod holder permanent mount board only

8 MHz Impedance: (Ohms): 50 Gain: 6 dB Max Input (Watts): 50 DC Ground: NO - the antenna will read "open circuit" when checked with an ohm meter or continuity tester

The maximum charger current offered by echocharge is limited to 15 amps

Label backlighting pre-installed

PN:  7144

Raymarine 20M Backbone Cable f/SeaTalkng [A06037] Lighting | Interior / Courtesy Light 362 Triple rod holder permanentBackbone Cables In a SeaTalkng installation, a backbone cable runs through the length of the boat. Individual devices connect to the backbone by spur cables that run to T pieces on the backbone. The backbone carries both data and power to attached devices. The backbone should be sized so that it will run past every location where an NG or NMEA 2000 device might be installed. Two backbone cable lengths can be joined together by part A06030, a backbone